Key Features for TENS Pro 900 & Pro 900
* A safe & easy to use hand-held device, operating on 9V battery
* There are no gels, needles, pads, electrical wires, plugs or fiddling
around.
* Search & stimulate using the same push/release button
* Skin Sensitivity Control panal assist point detection
* Meridian balancing can be achieved by selecting the appropriate the
polarity switch - Tonify (+) or Disperse (-).
* The intensity control, located in the battery compartment, is
adjustable
* An extension probe is included for those hard to reach areas.
* A complimentary book, Alternative Healthcare Treatment, written by
Mark Ralph, is included for both TENS Pro & the Pro 900 units.
* A demonstration VHS tape is also included in the Pro 900
* Backed by a one year warranty
Description of Electrical Performance:
The device is powered by a 9-volt battery. The electrical output of the
device consists of square waveform pulse. The pulse parameters vary
with skin impedance.
During the search mode, testing from 0 to 100K Ohms (skin
impedance) gives the following output parameters:
Voltage 0.15 - 4 V
Pulse length 0.3 - 3.6 millsec
Frequency 200 Hz to 2KHz
During the stimulation mode, pulses have the following output
parameters at a skin impedance off 100K Ohms:
Voltage 0 - 8.8 V
Frequency 2.5Hz
The pulse output in the stimulation can be varied with the intensity
setting in the battery compartment (see table below).
Maximum peak pulse length is 300 milliseconds for the +stimulation
mode and 300 milliseconds for the -stimulation mode.
|
The inbuild audiovisual signal system & the unique skin sensitivity control panel allow exact acupuncture point location while the adjustable intensity control, located in the battery compartment, allows intensity to be varied to best suit your patient's requirement.
